A 200 ton road-rail transfer cart moves heavy loads over two kinds of ground: factory floors and railway tracks. One vehicle carries two running systems and a mechanism to switch between them. This article covers how the cart runs in each mode, what the changeover actually does, and which parameters are set per project.
Motors: PMAC / AC high efficiency motors
Wheels: Cast Steel / Polyurethane Wheel.
Road mode. The cart runs on road wheels over concrete floors, asphalt yards and loading zones. It moves between workshops and storage areas without a track being laid first. Steering type and turning radius follow the floor layout — four-wheel steering for tight aisles, straight-line shuttle for long transfer runs.
Rail mode. The cart runs on rail wheels matched to your track. Wheel profile and gauge follow the rail specification on site — 1435 mm standard gauge, or a narrower in-plant gauge. On rail it travels along existing lines inside a plant or a railway maintenance depot.
Changing modes. The changeover is mechanical: the platform is lifted to raise one wheel set and lower the other, rail wheels retract, or a similar arrangement fixed at design stage. The control system confirms the correct wheel set is fully engaged and locked before it allows travel. The cart cannot move with both systems half-engaged.
Compared with a light rail transfer cart, 200 tons affects three parts of the design:
A trackless transfer cart is built for floors only. This cart covers both routes, so one unit replaces two on a mixed road-and-rail flow.
The following specifications provide a preliminary reference. Final parameters are determined according to project requirements.
| Item | Technical Parameters |
| Product Name | Road-Rail Transfer Cart |
| Rated Load Capacity | 200 Tons |
| Transportation Modes | Road and Rail |
| Running System | Customized Road and Rail Wheel Assemblies |
| Drive System | Electric Drive |
| Control Method | Wireless Remote Control / PLC Control |
| Rail Gauge | Customized According to Project |
| Platform Dimensions | Customized |
| Safety Devices | Emergency Stop, Warning Lights, Safety Interlocks |
| Application | Steel Plants, Railway Workshops, Heavy Manufacturing |
360 degree motorized rotation without causing any damage to the floor.
Powered by storage battery, turning freely without any cable strings.
Controlled easily by pressing the buttons and speed controller.
High level automation(self propelled/steerable)
The largest capacity can reach to 100t
Safe parts are installed in the transfer cart(warning light, e-stop, buffer...)
Robust sturdy car frame
Please feel free to give your inquiry in the form below .We will reply you in 24 hours .
One vehicle with a road wheel system and a rail wheel system. It runs on factory ground, switches to track when the route calls for it.
Lifting the platform, retracting the rail wheels, or another mechanical arrangement. Interlocks confirm the active wheel set is engaged and the other is clear before the cart moves.
Yes. Gauge follows your track — 1435 mm standard or a non-standard in-plant gauge. Platform size follows the footprint of the load.
Battery (lithium or lead-acid), cable drum, busbar, or diesel and hybrid for outdoor work. Choice depends on transport distance and duty cycle.
1 to 300 t. 200 t is the common size for steel plants and railway workshops.